To completely upload data to the Agora system, you need to launch the infobase in 1C Enterprise mode and log in.

The complete unloading process may differ depending on the version of the 1C edition used.

Before performing a full unload, the following steps must be taken:

Go to section All functions

Go to the Exchange plans section:

Select Agora exchange in the list:

Click on the Create nodes button:

Make sure the nodes are created:

Fill in all the data in the upload setting, except for the item upload filter.
Basic tab:

Filter by Warehouse tab:

Filter by prices tab:

Filter tab by attributes and properties:

Exchange parameters tab:

Write down this data, then perform a complete upload.

Full unload only needs to be performed once, immediately after connection. In the future, changes in the system according to the nomenclature will be registered and unloaded automatically when the check-boxes Enable registration of changes and Enable exchange by schedule are checked, when configuring the operation of the data exchange gateway with the Agora system.
Then mark the filter for unloading the nomenclature and enable the exchange checkboxes.

To start a full unloading of any version of the edition (except for Alfa-auto, UPP 1.3, UT 10.3), after installing the Agora gateway, go to the Agora section displayed on the main page of the 1C enterprise:

To start a full unloading into Alfa-auto, UPP 1.3, UT 10.3, after installing the Agora gateway, go along the path:

In the 1C enterprise interface, open Operations → Processing → Complete unloading portal → Execute: